arm64: dts: orange-pi-zero-plus2: enable AP6212a WiFi/BT combo

Enable AP6212a WiFi/BT combo chip on orange-pi-zero-plus2 board:
- WiFi SDIO interface is connected to MMC1
- WiFi REG_ON pin connected to gpio PA9: attach to mmc-pwrseq
- WiFi HOST_WAKE pin connected to gpio PL7
- BT is connected to UART1

Signed-off-by: Sergey Matyukevich <geomatsi@gmail.com>
Signed-off-by: Maxime Ripard <maxime.ripard@free-electrons.com>
This commit is contained in:
Sergey Matyukevich 2017-11-03 22:58:55 +03:00 committed by Maxime Ripard
parent 4fbd8d194f
commit cf8e19e1ec

View File

@ -64,6 +64,13 @@
regulator-min-microvolt = <3300000>;
regulator-max-microvolt = <3300000>;
};
wifi_pwrseq: wifi_pwrseq {
compatible = "mmc-pwrseq-simple";
pinctrl-names = "default";
reset-gpios = <&pio 0 9 GPIO_ACTIVE_LOW>; /* PA9 */
post-power-on-delay-ms = <200>;
};
};
&mmc0 {
@ -75,6 +82,25 @@
status = "okay";
};
&mmc1 {
pinctrl-names = "default";
pinctrl-0 = <&mmc1_pins_a>;
vmmc-supply = <&reg_vcc3v3>;
vqmmc-supply = <&reg_vcc3v3>;
mmc-pwrseq = <&wifi_pwrseq>;
bus-width = <4>;
non-removable;
status = "okay";
brcmf: wifi@1 {
reg = <1>;
compatible = "brcm,bcm4329-fmac";
interrupt-parent = <&r_pio>;
interrupts = <0 7 IRQ_TYPE_LEVEL_LOW>; /* PL7 */
interrupt-names = "host-wake";
};
};
&mmc2 {
pinctrl-names = "default";
pinctrl-0 = <&mmc2_8bit_pins>;
@ -90,3 +116,9 @@
pinctrl-0 = <&uart0_pins_a>;
status = "okay";
};
&uart1 {
pinctrl-names = "default";
pinctrl-0 = <&uart1_pins>, <&uart1_rts_cts_pins>;
status = "okay";
};