forked from Minki/linux
37 lines
1.2 KiB
Plaintext
37 lines
1.2 KiB
Plaintext
|
Qualcomm Quad Serial Peripheral Interface (QSPI)
|
||
|
|
|
||
|
|
The QSPI controller allows SPI protocol communication in single, dual, or quad
|
||
|
|
wire transmission modes for read/write access to slaves such as NOR flash.
|
||
|
|
|
||
|
|
Required properties:
|
||
|
|
- compatible: An SoC specific identifier followed by "qcom,qspi-v1", such as
|
||
|
|
"qcom,sdm845-qspi", "qcom,qspi-v1"
|
||
|
|
- reg: Should contain the base register location and length.
|
||
|
|
- interrupts: Interrupt number used by the controller.
|
||
|
|
- clocks: Should contain the core and AHB clock.
|
||
|
|
- clock-names: Should be "core" for core clock and "iface" for AHB clock.
|
||
|
|
|
||
|
|
SPI slave nodes must be children of the SPI master node and can contain
|
||
|
|
properties described in Documentation/devicetree/bindings/spi/spi-bus.txt
|
||
|
|
|
||
|
|
Example:
|
||
|
|
|
||
|
|
qspi: spi@88df000 {
|
||
|
|
compatible = "qcom,sdm845-qspi", "qcom,qspi-v1";
|
||
|
|
reg = <0x88df000 0x600>;
|
||
|
|
#address-cells = <1>;
|
||
|
|
#size-cells = <0>;
|
||
|
|
interrupts = <GIC_SPI 82 IRQ_TYPE_LEVEL_HIGH>;
|
||
|
|
clock-names = "iface", "core";
|
||
|
|
clocks = <&gcc GCC_QSPI_CNOC_PERIPH_AHB_CLK>,
|
||
|
|
<&gcc GCC_QSPI_CORE_CLK>;
|
||
|
|
|
||
|
|
flash@0 {
|
||
|
|
compatible = "jedec,spi-nor";
|
||
|
|
reg = <0>;
|
||
|
|
spi-max-frequency = <25000000>;
|
||
|
|
spi-tx-bus-width = <2>;
|
||
|
|
spi-rx-bus-width = <2>;
|
||
|
|
};
|
||
|
|
};
|