mirror of
https://github.com/torvalds/linux.git
synced 2024-11-05 11:32:04 +00:00
c3bc4caedd
This patch adds support for the MAX6875/MAX6874 chips. Signed-off-by: Ben Gardner <bgardner@wabtec.com> Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
55 lines
1.4 KiB
Plaintext
55 lines
1.4 KiB
Plaintext
Kernel driver max6875
|
|
=====================
|
|
|
|
Supported chips:
|
|
* Maxim max6874, max6875
|
|
Prefixes: 'max6875'
|
|
Addresses scanned: 0x50, 0x52
|
|
Datasheets:
|
|
http://pdfserv.maxim-ic.com/en/ds/MAX6874-MAX6875.pdf
|
|
|
|
Author: Ben Gardner <bgardner@wabtec.com>
|
|
|
|
|
|
Module Parameters
|
|
-----------------
|
|
|
|
* allow_write int
|
|
Set to non-zero to enable write permission:
|
|
*0: Read only
|
|
1: Read and write
|
|
|
|
|
|
Description
|
|
-----------
|
|
|
|
The MAXIM max6875 is a EEPROM-programmable power-supply sequencer/supervisor.
|
|
It provides timed outputs that can be used as a watchdog, if properly wired.
|
|
It also provides 512 bytes of user EEPROM.
|
|
|
|
At reset, the max6875 reads the configuration eeprom into its configuration
|
|
registers. The chip then begins to operate according to the values in the
|
|
registers.
|
|
|
|
See the datasheet for details on how to program the EEPROM.
|
|
|
|
|
|
Sysfs entries
|
|
-------------
|
|
|
|
eeprom_user - 512 bytes of user-defined EEPROM space. Only writable if
|
|
allow_write was set and register 0x43 is 0.
|
|
|
|
eeprom_config - 70 bytes of config EEPROM. Note that changes will not get
|
|
loaded into register space until a power cycle or device reset.
|
|
|
|
reg_config - 70 bytes of register space. Any changes take affect immediately.
|
|
|
|
|
|
General Remarks
|
|
---------------
|
|
|
|
A typical application will require that the EEPROMs be programmed once and
|
|
never altered afterwards.
|
|
|