linux/Documentation/devicetree/bindings/input/touchscreen/hideep.txt
Anthony Kim 842ff28616 Input: add support for HiDeep touchscreen
The HiDeep touchscreen device is a capacitive multi-touch controller
mainly for multi-touch supported devices use. It use I2C interface for
communication to IC and provide axis X, Y, Z locations for ten finger
touch through input event interface to userspace.

It support the Crimson and the Lime two type IC. They are different
the number of channel supported and FW size. But the working protocol
is same.

Signed-off-by: Anthony Kim <anthony.kim@hideep.com>
Acked-by: Rob Herring <robh+dt@kernel.org>
Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>
2017-11-10 10:18:22 -08:00

43 lines
1.2 KiB
Plaintext

* HiDeep Finger and Stylus touchscreen controller
Required properties:
- compatible : must be "hideep,hideep-ts"
- reg : I2C slave address, (e.g. 0x6C).
- interrupt-parent : Interrupt controller to which the chip is connected.
- interrupts : Interrupt to which the chip is connected.
Optional properties:
- vdd-supply : It is the controller supply for controlling
main voltage(3.3V) through the regulator.
- vid-supply : It is the controller supply for controlling
IO voltage(1.8V) through the regulator.
- reset-gpios : Define for reset gpio pin.
It is to use for reset IC.
- touchscreen-size-x : X axis size of touchscreen
- touchscreen-size-y : Y axis size of touchscreen
- linux,keycodes : Specifies an array of numeric keycode values to
be used for reporting button presses. The array can
contain up to 3 entries.
Example:
#include "dt-bindings/input/input.h"
i2c@00000000 {
/* ... */
touchscreen@6c {
compatible = "hideep,hideep-ts";
reg = <0x6c>;
interrupt-parent = <&gpx1>;
interrupts = <2 IRQ_TYPE_LEVEL_LOW>;
vdd-supply = <&ldo15_reg>";
vid-supply = <&ldo18_reg>;
reset-gpios = <&gpx1 5 0>;
touchscreen-size-x = <1080>;
touchscreen-size-y = <1920>;
linux,keycodes = <KEY_HOME>, <KEY_MENU>, <KEY_BACK>;
};
};