mirror of
https://github.com/torvalds/linux.git
synced 2024-12-02 09:01:34 +00:00
9f7195da31
The SAMA5D2 NRST input signal is resynchronized with the SLCK clock and it can take up to 2 SLCK cycles (about 90us) for the internal reset to be effective. During this delay, the VDDCORE current consumption may still be high (application-dependent) with the VDDCORE regulator already OFF. Under such conditions, VDDCORE may operate below its operating range leading to potential register corruption. To prevent such situation, it is recommended to decrease significantly the power consumption of the device once the voltage regulator is turned-off. This can be achieved by operating the device at a much lower low frequency. To solve this switch the master clock to slock clock just before writing shutdown command to shutdown controller. Signed-off-by: Claudiu Beznea <claudiu.beznea@microchip.com> Suggested-by: Patrice Vilchez <patrice.vilchez@microchip.com> Acked-by: Nicolas Ferre <nicolas.ferre@microchip.com> Signed-off-by: Sebastian Reichel <sebastian.reichel@collabora.com> |
||
|---|---|---|
| .. | ||
| arm-versatile-reboot.c | ||
| as3722-poweroff.c | ||
| at91-poweroff.c | ||
| at91-reset.c | ||
| at91-sama5d2_shdwc.c | ||
| axxia-reset.c | ||
| brcm-kona-reset.c | ||
| brcmstb-reboot.c | ||
| gemini-poweroff.c | ||
| gpio-poweroff.c | ||
| gpio-restart.c | ||
| hisi-reboot.c | ||
| Kconfig | ||
| keystone-reset.c | ||
| ltc2952-poweroff.c | ||
| Makefile | ||
| msm-poweroff.c | ||
| ocelot-reset.c | ||
| piix4-poweroff.c | ||
| qcom-pon.c | ||
| qnap-poweroff.c | ||
| reboot-mode.c | ||
| restart-poweroff.c | ||
| rmobile-reset.c | ||
| sc27xx-poweroff.c | ||
| st-poweroff.c | ||
| syscon-poweroff.c | ||
| syscon-reboot-mode.c | ||
| syscon-reboot.c | ||
| vexpress-poweroff.c | ||
| xgene-reboot.c | ||
| zx-reboot.c | ||