mirror of
https://github.com/torvalds/linux.git
synced 2024-12-25 12:21:37 +00:00
c46af3124b
The TAS5086 has two power domains, DVDD and AVDD. Enable them both as long as the codec is in use. Also, switch on the power to identify the chip at device probe level, and switch it off again afterwards. The codec level will take care for power handling later. Signed-off-by: Daniel Mack <zonque@gmail.com> Signed-off-by: Mark Brown <broonie@linaro.org>
49 lines
1.5 KiB
Plaintext
49 lines
1.5 KiB
Plaintext
Texas Instruments TAS5086 6-channel PWM Processor
|
|
|
|
Required properties:
|
|
|
|
- compatible: Should contain "ti,tas5086".
|
|
- reg: The i2c address. Should contain <0x1b>.
|
|
|
|
Optional properties:
|
|
|
|
- reset-gpio: A GPIO spec to define which pin is connected to the
|
|
chip's !RESET pin. If specified, the driver will
|
|
assert a hardware reset at probe time.
|
|
|
|
- ti,charge-period: This property should contain the time in microseconds
|
|
that closely matches the external single-ended
|
|
split-capacitor charge period. The hardware chip
|
|
waits for this period of time before starting the
|
|
PWM signals. This helps reduce pops and clicks.
|
|
|
|
When not specified, the hardware default of 1300ms
|
|
is retained.
|
|
|
|
- ti,mid-z-channel-X: Boolean properties, X being a number from 1 to 6.
|
|
If given, channel X will start with the Mid-Z start
|
|
sequence, otherwise the default Low-Z scheme is used.
|
|
|
|
The correct configuration depends on how the power
|
|
stages connected to the PWM output pins work. Not all
|
|
power stages are compatible to Mid-Z - please refer
|
|
to the datasheets for more details.
|
|
|
|
Most systems should not set any of these properties.
|
|
|
|
- avdd-supply: Power supply for AVDD, providing 3.3V
|
|
- dvdd-supply: Power supply for DVDD, providing 3.3V
|
|
|
|
Examples:
|
|
|
|
i2c_bus {
|
|
tas5086@1b {
|
|
compatible = "ti,tas5086";
|
|
reg = <0x1b>;
|
|
reset-gpio = <&gpio 23 0>;
|
|
ti,charge-period = <156000>;
|
|
avdd-supply = <&vdd_3v3_reg>;
|
|
dvdd-supply = <&vdd_3v3_reg>;
|
|
};
|
|
};
|