mirror of
https://github.com/torvalds/linux.git
synced 2024-12-25 12:21:37 +00:00
3648dc6d27
In order to align with st21nfca, dts configuration properties ese_present and uicc_present are made available in st-nci driver. So far, in early development firmware, because nci_nfcee_mode_set(DISABLE) was not supported we had to try to enable it during the secure element discovery phase. After several trials on commercial and qualified firmware it appears that nci_nfcee_mode_set(ENABLE) and nci_nfcee_mode_set(DISABLE) are properly supported. Such feature also help us to eventually save some time (~5ms) when only one secure element is connected. Acked-by: Rob Herring <robh@kernel.org> Signed-off-by: Christophe Ricard <christophe-h.ricard@st.com> Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>
39 lines
1.0 KiB
Plaintext
39 lines
1.0 KiB
Plaintext
* STMicroelectronics SAS. ST NCI NFC Controller
|
|
|
|
Required properties:
|
|
- compatible: Should be "st,st21nfcb-spi"
|
|
- spi-max-frequency: Maximum SPI frequency (<= 4000000).
|
|
- interrupt-parent: phandle for the interrupt gpio controller
|
|
- interrupts: GPIO interrupt to which the chip is connected
|
|
- reset-gpios: Output GPIO pin used to reset the ST21NFCB
|
|
|
|
Optional SoC Specific Properties:
|
|
- pinctrl-names: Contains only one value - "default".
|
|
- pintctrl-0: Specifies the pin control groups used for this controller.
|
|
- ese-present: Specifies that an ese is physically connected to the nfc
|
|
controller.
|
|
- uicc-present: Specifies that the uicc swp signal can be physically
|
|
connected to the nfc controller.
|
|
|
|
Example (for ARM-based BeagleBoard xM with ST21NFCB on SPI4):
|
|
|
|
&mcspi4 {
|
|
|
|
status = "okay";
|
|
|
|
st21nfcb: st21nfcb@0 {
|
|
|
|
compatible = "st,st21nfcb-spi";
|
|
|
|
clock-frequency = <4000000>;
|
|
|
|
interrupt-parent = <&gpio5>;
|
|
interrupts = <2 IRQ_TYPE_EDGE_RISING>;
|
|
|
|
reset-gpios = <&gpio5 29 GPIO_ACTIVE_HIGH>;
|
|
|
|
ese-present;
|
|
uicc-present;
|
|
};
|
|
};
|