mirror of
https://github.com/torvalds/linux.git
synced 2024-12-30 14:52:05 +00:00
324e46cee1
Amlogic Meson GXL SoCs use a dwc3 controller with two (GXM - a variant for GXL, has three) USB2 ports. The first USB2 port supports host and peripheral (also called "device") mode. While the dwc3 controller has no USB3 port enabled we still need the USB3 PHY to be initialized. Otherwise high-speed USB transfers (for example with a USB flash drive) may time out (most often seen on boards with mainline u-boot, where the bootloader does not initialize the USB3 PHY registers). Signed-off-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com> Reviewed-by: Rob Herring <robh@kernel.org> Tested-by: Yixun Lan <yixun.lan@amlogic.com> Tested-by: Neil Armstrong <narmstrong@baylibre.com> Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com>
32 lines
1.0 KiB
Plaintext
32 lines
1.0 KiB
Plaintext
* Amlogic Meson GXL and GXM USB3 PHY and OTG detection binding
|
|
|
|
Required properties:
|
|
- compatible: Should be "amlogic,meson-gxl-usb3-phy"
|
|
- #phys-cells: must be 0 (see phy-bindings.txt in this directory)
|
|
- reg: The base address and length of the registers
|
|
- interrupts: the interrupt specifier for the OTG detection
|
|
- clocks: phandles to the clocks for
|
|
- the USB3 PHY
|
|
- and peripheral mode/OTG detection
|
|
- clock-names: must contain "phy" and "peripheral"
|
|
- resets: phandle to the reset lines for:
|
|
- the USB3 PHY and
|
|
- peripheral mode/OTG detection
|
|
- reset-names: must contain "phy" and "peripheral"
|
|
|
|
Optional properties:
|
|
- phy-supply: see phy-bindings.txt in this directory
|
|
|
|
|
|
Example:
|
|
usb3_phy0: phy@78080 {
|
|
compatible = "amlogic,meson-gxl-usb3-phy";
|
|
#phy-cells = <0>;
|
|
reg = <0x0 0x78080 0x0 0x20>;
|
|
interrupts = <GIC_SPI 16 IRQ_TYPE_LEVEL_HIGH>;
|
|
clocks = <&clkc CLKID_USB_OTG>, <&clkc_AO CLKID_AO_CEC_32K>;
|
|
clock-names = "phy", "peripheral";
|
|
resets = <&reset RESET_USB_OTG>, <&reset RESET_USB_OTG>;
|
|
reset-names = "phy", "peripheral";
|
|
};
|