mirror of
https://github.com/torvalds/linux.git
synced 2024-12-15 15:41:58 +00:00
1da177e4c3
Initial git repository build. I'm not bothering with the full history, even though we have it. We can create a separate "historical" git archive of that later if we want to, and in the meantime it's about 3.2GB when imported into git - space that would just make the early git days unnecessarily complicated, when we don't have a lot of good infrastructure for it. Let it rip!
47 lines
1.7 KiB
Plaintext
47 lines
1.7 KiB
Plaintext
#
|
|
# Acorn Network device configuration
|
|
# These are for Acorn's Expansion card network interfaces
|
|
#
|
|
config ARM_AM79C961A
|
|
bool "ARM EBSA110 AM79C961A support"
|
|
depends on NET_ETHERNET && ARM && ARCH_EBSA110
|
|
select CRC32
|
|
help
|
|
If you wish to compile a kernel for the EBSA-110, then you should
|
|
always answer Y to this.
|
|
|
|
config ARM_ETHER1
|
|
tristate "Acorn Ether1 support"
|
|
depends on NET_ETHERNET && ARM && ARCH_ACORN
|
|
help
|
|
If you have an Acorn system with one of these (AKA25) network cards,
|
|
you should say Y to this option if you wish to use it with Linux.
|
|
|
|
config ARM_ETHER3
|
|
tristate "Acorn/ANT Ether3 support"
|
|
depends on NET_ETHERNET && ARM && ARCH_ACORN
|
|
help
|
|
If you have an Acorn system with one of these network cards, you
|
|
should say Y to this option if you wish to use it with Linux.
|
|
|
|
config ARM_ETHERH
|
|
tristate "I-cubed EtherH/ANT EtherM support"
|
|
depends on NET_ETHERNET && ARM && ARCH_ACORN
|
|
select CRC32
|
|
help
|
|
If you have an Acorn system with one of these network cards, you
|
|
should say Y to this option if you wish to use it with Linux.
|
|
|
|
config ARM_ETHER00
|
|
tristate "Altera Ether00 support"
|
|
depends on NET_ETHERNET && ARM && ARCH_CAMELOT
|
|
help
|
|
This is the driver for Altera's ether00 ethernet mac IP core. Say
|
|
Y here if you want to build support for this into the kernel. It
|
|
is also available as a module (say M here) that can be inserted/
|
|
removed from the kernel at the same time as the PLD is configured.
|
|
If this driver is running on an epxa10 development board then it
|
|
will generate a suitable hw address based on the board serial
|
|
number (MTD support is required for this). Otherwise you will
|
|
need to set a suitable hw address using ifconfig.
|