mirror of
https://github.com/torvalds/linux.git
synced 2024-12-26 04:42:12 +00:00
f651c73e71
It's used to support dual role switch via GPIO when use Type-B receptacle, typically the USB ID pin is connected to an input GPIO, and also used to enable/disable device when the USB Vbus pin is connected to an input GPIO. Signed-off-by: Chunfeng Yun <chunfeng.yun@mediatek.com> Reviewed-by: Linus Walleij <linus.walleij@linaro.org> Reviewed-by: Rob Herring <robh@kernel.org> Link: https://lore.kernel.org/r/1567070558-29417-4-git-send-email-chunfeng.yun@mediatek.com Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
31 lines
836 B
Plaintext
31 lines
836 B
Plaintext
USB GPIO Based Connection Detection
|
|
|
|
This is typically used to switch dual role mode from the USB ID pin connected
|
|
to an input GPIO, and also used to enable/disable device mode from the USB
|
|
Vbus pin connected to an input GPIO.
|
|
|
|
Required properties:
|
|
- compatible : should include "gpio-usb-b-connector" and "usb-b-connector".
|
|
- id-gpios, vbus-gpios : input gpios, either one of them must be present,
|
|
and both can be present as well.
|
|
see connector/usb-connector.txt
|
|
|
|
Optional properties:
|
|
- vbus-supply : can be present if needed when supports dual role mode.
|
|
see connector/usb-connector.txt
|
|
|
|
- Sub-nodes:
|
|
- port : can be present.
|
|
see graph.txt
|
|
|
|
Example:
|
|
|
|
&mtu3 {
|
|
connector {
|
|
compatible = "gpio-usb-b-connector", "usb-b-connector";
|
|
type = "micro";
|
|
id-gpios = <&pio 12 GPIO_ACTIVE_HIGH>;
|
|
vbus-supply = <&usb_p0_vbus>;
|
|
};
|
|
};
|