By default the LED will blink when there is some activity.
This was tested with a TP-Link TL-WN725N.
Signed-off-by: Bitterblue Smith <rtl8821cerfe2@gmail.com>
Reviewed-by: Ping-Ke Shih <pkshih@realtek.com>
Signed-off-by: Kalle Valo <kvalo@kernel.org>
Link: https://lore.kernel.org/r/34d62bf5-3595-0c77-2ca7-be78555f765d@gmail.com
Or in the case of RTL8188EU, report the RSSI to the rate control code.
The rate control code for RTL8188EU is less likely to switch to a lower
rate when the RSSI is high. The firmware-based rate control in the other
chips probably works the same way.
This affects all the chips, but it was only tested with RTL8188EU,
RTL8188FU, and RTL8192EU.
Signed-off-by: Bitterblue Smith <rtl8821cerfe2@gmail.com>
Reviewed-by: Ping-Ke Shih <pkshih@realtek.com>
Signed-off-by: Kalle Valo <kvalo@kernel.org>
Link: https://lore.kernel.org/r/2aab4f3f-e914-4fe1-f29a-deac91774d05@gmail.com
This chip is found in cheap USB devices from TP-Link, D-Link, etc.
Features: 2.4 GHz, b/g/n mode, 1T1R, 150 Mbps.
Chip versions older than "I cut" need software rate control. That will
be in the next commit. Until then MCS7 is used for all data frames.
The "I cut" chips are not supported. They require different firmware
and initialisation tables. Support can be added if someone has the
hardware to test it.
Co-developed-by: Andrea Merello <andrea.merello@gmail.com>
Signed-off-by: Andrea Merello <andrea.merello@gmail.com>
Co-developed-by: Taehee Yoo <ap420073@gmail.com>
Signed-off-by: Taehee Yoo <ap420073@gmail.com>
Signed-off-by: Jes Sorensen <Jes.Sorensen@gmail.com>
Co-developed-by: Bitterblue Smith <rtl8821cerfe2@gmail.com>
Signed-off-by: Bitterblue Smith <rtl8821cerfe2@gmail.com>
Reviewed-by: Ping-Ke Shih <pkshih@realtek.com>
Signed-off-by: Kalle Valo <kvalo@kernel.org>
Link: https://lore.kernel.org/r/3aad60f6-23f9-81e8-c741-4bd51e99f423@gmail.com
