Commit Graph

16 Commits

Author SHA1 Message Date
Thomas Gleixner
8e8e69d67e treewide: Replace GPLv2 boilerplate/reference with SPDX - rule 285
Based on 1 normalized pattern(s):

  this program is free software you can redistribute it and or modify
  it under the terms of the gnu general public license as published by
  the free software foundation version 2 of the license this program
  is distributed in the hope that it will be useful but without any
  warranty without even the implied warranty of merchantability or
  fitness for a particular purpose see the gnu general public license
  for more details

extracted by the scancode license scanner the SPDX license identifier

  GPL-2.0-only

has been chosen to replace the boilerplate/reference in 100 file(s).

Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Reviewed-by: Alexios Zavras <alexios.zavras@intel.com>
Reviewed-by: Allison Randal <allison@lohutok.net>
Cc: linux-spdx@vger.kernel.org
Link: https://lkml.kernel.org/r/20190529141900.918357685@linutronix.de
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2019-06-05 17:36:37 +02:00
Mike Looijmans
9e9a615103 zynq-fpga: Only route PR via PCAP when required
The Xilinx Zynq FPGA driver takes ownership of the PR interface, making
it impossible to use the ICAP interface for partial reconfiguration.

This patch changes the driver to only activate PR over PCAP while the
device is actively being accessed by the driver for programming.

This allows both PCAP and ICAP interfaces to be used for PR.

Signed-off-by: Mike Looijmans <mike.looijmans@topic.nl>
Reviewed-by: Moritz Fischer <mdf@kernel.org>
Acked-by: Alan Tull <atull@kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2018-11-11 12:58:27 -08:00
Alan Tull
084181fe8c fpga: mgr: add devm_fpga_mgr_create
Add devm_fpga_mgr_create() which is the managed
version of fpga_mgr_create().

Change current FPGA manager drivers to use
devm_fpga_mgr_create()

Signed-off-by: Alan Tull <atull@kernel.org>
Suggested-by: Federico Vaga <federico.vaga@cern.ch>
Acked-by: Moritz Fischer <mdf@kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2018-10-16 11:13:50 +02:00
Alan Tull
7085e2a94f fpga: manager: change api, don't use drvdata
Change fpga_mgr_register to not set or use drvdata.  This supports
the case where a PCIe device has more than one manager.

Add fpga_mgr_create/free functions.  Change fpga_mgr_register and
fpga_mgr_unregister functions to take the mgr struct as their only
parameter.

  struct fpga_manager *fpga_mgr_create(struct device *dev,
                const char *name,
                const struct fpga_manager_ops *mops,
                void *priv);
  void fpga_mgr_free(struct fpga_manager *mgr);
  int fpga_mgr_register(struct fpga_manager *mgr);
  void fpga_mgr_unregister(struct fpga_manager *mgr);

Update the drivers that call fpga_mgr_register with the new API.

Signed-off-by: Alan Tull <atull@kernel.org>
[Moritz: Fixup whitespace issue]
Reported-by: Jiuyue Ma <majiuyue@huawei.com>
Signed-off-by: Moritz Fischer <mdf@kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2018-05-25 18:23:55 +02:00
Moritz Fischer
7f33bbca14 fpga: zynq: Add support for encrypted bitstreams
Add support for encrypted bitstreams. For this to work the system
must be booted in secure mode.

In order for on-the-fly decryption to work, the PCAP clock rate
needs to be lowered via the PCAP_RATE_EN bit.

Signed-off-by: Moritz Fischer <mdf@kernel.org>
Acked-by: Michal Simek <michal.simek@xilinx.com>
Signed-off-by: Alan Tull <atull@kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2017-03-17 15:10:48 +09:00
Jason Gunthorpe
425902f5c8 fpga zynq: Use the scatterlist interface
This allows the driver to avoid a high order coherent DMA allocation
and memory copy. With this patch it can DMA directly from the kernel
pages that the bitfile is stored in.

Since this is now a gather DMA operation the driver uses the ISR
to feed the chips DMA queue with each entry from the SGL.

Signed-off-by: Jason Gunthorpe <jgunthorpe@obsidianresearch.com>
Acked-by: Moritz Fischer <moritz.fischer@ettus.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2017-02-10 15:20:44 +01:00
Jason Gunthorpe
b496df86ac fpga zynq: Check the bitstream for validity
There is no sense in sending a bitstream we know will not work, and
with the variety of options for bitstream generation in Xilinx tools
it is not terribly clear what the correct input should be.

This is particularly important for Zynq since auto-correction was
removed from the driver and the Zynq hardware only accepts a bitstream
format that is different from what the Xilinx tools typically produce.

Worse, the hardware provides no indication why the bitstream fails,
it simply times out if the input is wrong.

The best option here is to have the kernel print a message informing
the user they are using a malformed bistream and programming failure
isn't for any of the myriad of other reasons.

Signed-off-by: Jason Gunthorpe <jgunthorpe@obsidianresearch.com>
Acked-by: Moritz Fischer <moritz.fischer@ettus.com>
Acked-by: Alan Tull <atull@opensource.altera.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2017-02-10 15:20:44 +01:00
Jason Gunthorpe
6b45e0f24c fpga zynq: Check for errors after completing DMA
The completion did not check the interrupt status to see if any error
bits were asserted, check error bits and dump some registers if things
went wrong.

A few fixes are needed to make this work, the IXR_ERROR_FLAGS_MASK was
wrong, it included the done bits, which shows a bug in mask/unmask_irqs
which were using the wrong bits, simplify all of this stuff.

Signed-off-by: Jason Gunthorpe <jgunthorpe@obsidianresearch.com>
Reviewed-by: Moritz Fischer <moritz.fischer@ettus.com>
Acked-by: Alan Tull <atull@opensource.altera.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2017-02-10 15:20:44 +01:00
Jason Gunthorpe
340c0c53ea fpga zynq: Fix incorrect ISR state on bootup
It is best practice to clear and mask all interrupts before
associating the IRQ, and this should be done after the clock
is enabled.

This corrects a bad result from zynq_fpga_ops_state on bootup
where left over latched values in INT_STS_OFFSET caused it to
report an unconfigured FPGA as configured.

After this change the boot up operating state for an unconfigured
FPGA reports 'unknown'.

Signed-off-by: Jason Gunthorpe <jgunthorpe@obsidianresearch.com>
Acked-by: Alan Tull <atull@opensource.altera.com>
Acked-by: Moritz Fischer <moritz.fischer@ettus.com>
2016-11-29 15:51:48 -06:00
Jason Gunthorpe
80baf649c2 fpga zynq: Remove priv->dev
socfpga uses mgr->dev for debug prints, there should be consistency
here, so standardize on that. The only other use was for dma
which can be replaced with mgr->dev.parent.

Signed-off-by: Jason Gunthorpe <jgunthorpe@obsidianresearch.com>
Acked-by: Alan Tull <atull@opensource.altera.com>
Acked-by: Moritz Fischer <moritz.fischer@ettus.com>
2016-11-29 15:51:46 -06:00
Jason Gunthorpe
1930c28651 fpga zynq: Add missing \n to messages
Function dev_err doesn't add a newline at the end of the string. This will
lead to a hard to read kernel log.

Signed-off-by: Jason Gunthorpe <jgunthorpe@obsidianresearch.com>
Reviewed-by: Moritz Fischer <moritz.fischer@ettus.com>
Reviewed-by: Matthias Brugger <mbrugger@suse.com>
Acked-by: Alan Tull <atull@opensource.altera.com>
2016-11-29 15:51:45 -06:00
Alan Tull
1df2865f8d fpga-mgr: add fpga image information struct
This patch adds a minor change in the FPGA Manager API
to hold information that is specific to an FPGA image
file.  This change is expected to bring little, if any,
pain.  The socfpga and zynq drivers are fixed up in
this patch.

An FPGA image file will have particulars that affect how the
image is programmed to the FPGA.  One example is that
current 'flags' currently has one bit which shows whether the
FPGA image was built for full reconfiguration or partial
reconfiguration.  Another example is timeout values for
enabling or disabling the bridges in the FPGA.  As the
complexity of the FPGA design increases, the bridges in the
FPGA may take longer times to enable or disable.

This patch adds a new 'struct fpga_image_info', moves the
current 'u32 flags' to it.  Two other image-specific u32's
are added for the bridge enable/disable timeouts.  The FPGA
Manager API functions are changed, replacing the 'u32 flag'
parameter with a pointer to struct fpga_image_info.
Subsequent patches fix the existing low level FPGA manager
drivers.

Signed-off-by: Alan Tull <atull@opensource.altera.com>
Acked-by: Moritz Fischer <moritz.fischer@ettus.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2016-11-10 17:03:35 +01:00
Moritz Fischer
28f98a12f7 fpga: zynq-fpga: Fix issue with drvdata being overwritten.
Upon registering a FPGA Manager low level driver, FPGA Manager
core overwrites the platform drvdata pointer. Prior to this commit
zynq-fpga falsely relied on this pointer to still be valid at remove()
time.

Reported-by: Alan Tull <atull@opensource.altera.com>
Signed-off-by: Moritz Fischer <moritz.fischer@ettus.com>
Acked-by: Alan Tull <atull@opensource.altera.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2015-10-23 16:49:44 -07:00
Moritz Fischer
4d10eaff5b fpga: zynq-fpga: Change fw format to handle bin instead of bit.
This gets rid of the code to strip away the header and byteswap,
as well as the check for the sync word.

Signed-off-by: Moritz Fischer <moritz.fischer@ettus.com>
Reviewed-by: Josh Cartwright <joshc@ni.com>
Acked-by: Michal Simek <michal.simek@xilinx.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2015-10-23 16:49:12 -07:00
Moritz Fischer
6376931bab fpga: zynq-fpga: Fix unbalanced clock handling
This commit fixes the unbalanced clock handling, where
a failed probe would leave the clock with an enable count of -1.

Reported-by: Josh Cartwright <joshc@ni.com>
Signed-off-by: Moritz Fischer <moritz.fischer@ettus.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2015-10-23 16:49:12 -07:00
Moritz Fischer
37784706bf fpga manager: Adding FPGA Manager support for Xilinx Zynq 7000
This commit adds FPGA Manager support for the Xilinx Zynq chip.
The code borrows some from the xdevcfg driver in Xilinx'
vendor tree.

Signed-off-by: Moritz Fischer <moritz.fischer@ettus.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2015-10-17 21:57:16 -07:00