net: allow user to set metric on default route learned via Router Advertisement

For IPv4, default route is learned via DHCPv4 and user is allowed to change
metric using config etc/network/interfaces. But for IPv6, default route can
be learned via RA, for which, currently a fixed metric value 1024 is used.

Ideally, user should be able to configure metric on default route for IPv6
similar to IPv4. This patch adds sysctl for the same.

Logs:

For IPv4:

Config in etc/network/interfaces:
auto eth0
iface eth0 inet dhcp
    metric 4261413864

IPv4 Kernel Route Table:
$ ip route list
default via 172.21.47.1 dev eth0 metric 4261413864

FRR Table, if a static route is configured:
[In real scenario, it is useful to prefer BGP learned default route over DHCPv4 default route.]
Codes: K - kernel route, C - connected, S - static, R - RIP,
       O - OSPF, I - IS-IS, B - BGP, P - PIM, E - EIGRP, N - NHRP,
       T - Table, v - VNC, V - VNC-Direct, A - Babel, D - SHARP,
       > - selected route, * - FIB route

S>* 0.0.0.0/0 [20/0] is directly connected, eth0, 00:00:03
K   0.0.0.0/0 [254/1000] via 172.21.47.1, eth0, 6d08h51m

i.e. User can prefer Default Router learned via Routing Protocol in IPv4.
Similar behavior is not possible for IPv6, without this fix.

After fix [for IPv6]:
sudo sysctl -w net.ipv6.conf.eth0.net.ipv6.conf.eth0.ra_defrtr_metric=1996489705

IP monitor: [When IPv6 RA is received]
default via fe80::xx16:xxxx:feb3:ce8e dev eth0 proto ra metric 1996489705  pref high

Kernel IPv6 routing table
$ ip -6 route list
default via fe80::be16:65ff:feb3:ce8e dev eth0 proto ra metric 1996489705 expires 21sec hoplimit 64 pref high

FRR Table, if a static route is configured:
[In real scenario, it is useful to prefer BGP learned default route over IPv6 RA default route.]
Codes: K - kernel route, C - connected, S - static, R - RIPng,
       O - OSPFv3, I - IS-IS, B - BGP, N - NHRP, T - Table,
       v - VNC, V - VNC-Direct, A - Babel, D - SHARP,
       > - selected route, * - FIB route

S>* ::/0 [20/0] is directly connected, eth0, 00:00:06
K   ::/0 [119/1001] via fe80::xx16:xxxx:feb3:ce8e, eth0, 6d07h43m

If the metric is changed later, the effect will be seen only when next IPv6
RA is received, because the default route must be fully controlled by RA msg.
Below metric is changed from 1996489705 to 1996489704.

$ sudo sysctl -w net.ipv6.conf.eth0.ra_defrtr_metric=1996489704
net.ipv6.conf.eth0.ra_defrtr_metric = 1996489704

IP monitor:
[On next IPv6 RA msg, Kernel deletes prev route and installs new route with updated metric]

Deleted default via fe80::xx16:xxxx:feb3:ce8e dev eth0 proto ra metric 1996489705 expires 3sec hoplimit 64 pref high
default via fe80::xx16:xxxx:feb3:ce8e dev eth0 proto ra metric 1996489704 pref high

Signed-off-by: Praveen Chaudhary <pchaudhary@linkedin.com>
Signed-off-by: Zhenggen Xu <zxu@linkedin.com>
Reviewed-by: David Ahern <dsahern@kernel.org>
Link: https://lore.kernel.org/r/20210125214430.24079-1-pchaudhary@linkedin.com
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
This commit is contained in:
Praveen Chaudhary 2021-01-25 13:44:30 -08:00 committed by Jakub Kicinski
parent 6626a02665
commit 6b2e04bc24
8 changed files with 37 additions and 7 deletions

View File

@ -1871,6 +1871,16 @@ accept_ra_defrtr - BOOLEAN
- enabled if accept_ra is enabled.
- disabled if accept_ra is disabled.
ra_defrtr_metric - UNSIGNED INTEGER
Route metric for default route learned in Router Advertisement. This value
will be assigned as metric for the default route learned via IPv6 Router
Advertisement. Takes affect only if accept_ra_defrtr is enabled.
Possible values:
1 to 0xFFFFFFFF
Default: IP6_RT_PRIO_USER i.e. 1024.
accept_ra_from_local - BOOLEAN
Accept RA with source-address that is found on local machine
if the RA is otherwise proper and able to be accepted.

View File

@ -31,6 +31,7 @@ struct ipv6_devconf {
__s32 max_desync_factor;
__s32 max_addresses;
__s32 accept_ra_defrtr;
__u32 ra_defrtr_metric;
__s32 accept_ra_min_hop_limit;
__s32 accept_ra_pinfo;
__s32 ignore_routes_with_linkdown;

View File

@ -174,7 +174,8 @@ struct fib6_info *rt6_get_dflt_router(struct net *net,
struct net_device *dev);
struct fib6_info *rt6_add_dflt_router(struct net *net,
const struct in6_addr *gwaddr,
struct net_device *dev, unsigned int pref);
struct net_device *dev, unsigned int pref,
u32 defrtr_usr_metric);
void rt6_purge_dflt_routers(struct net *net);

View File

@ -189,6 +189,7 @@ enum {
DEVCONF_ACCEPT_RA_RT_INFO_MIN_PLEN,
DEVCONF_NDISC_TCLASS,
DEVCONF_RPL_SEG_ENABLED,
DEVCONF_RA_DEFRTR_METRIC,
DEVCONF_MAX
};

View File

@ -571,6 +571,7 @@ enum {
NET_IPV6_ACCEPT_SOURCE_ROUTE=25,
NET_IPV6_ACCEPT_RA_FROM_LOCAL=26,
NET_IPV6_ACCEPT_RA_RT_INFO_MIN_PLEN=27,
NET_IPV6_RA_DEFRTR_METRIC=28,
__NET_IPV6_MAX
};

View File

@ -205,6 +205,7 @@ static struct ipv6_devconf ipv6_devconf __read_mostly = {
.max_desync_factor = MAX_DESYNC_FACTOR,
.max_addresses = IPV6_MAX_ADDRESSES,
.accept_ra_defrtr = 1,
.ra_defrtr_metric = IP6_RT_PRIO_USER,
.accept_ra_from_local = 0,
.accept_ra_min_hop_limit= 1,
.accept_ra_pinfo = 1,
@ -260,6 +261,7 @@ static struct ipv6_devconf ipv6_devconf_dflt __read_mostly = {
.max_desync_factor = MAX_DESYNC_FACTOR,
.max_addresses = IPV6_MAX_ADDRESSES,
.accept_ra_defrtr = 1,
.ra_defrtr_metric = IP6_RT_PRIO_USER,
.accept_ra_from_local = 0,
.accept_ra_min_hop_limit= 1,
.accept_ra_pinfo = 1,
@ -5476,6 +5478,7 @@ static inline void ipv6_store_devconf(struct ipv6_devconf *cnf,
array[DEVCONF_MAX_DESYNC_FACTOR] = cnf->max_desync_factor;
array[DEVCONF_MAX_ADDRESSES] = cnf->max_addresses;
array[DEVCONF_ACCEPT_RA_DEFRTR] = cnf->accept_ra_defrtr;
array[DEVCONF_RA_DEFRTR_METRIC] = cnf->ra_defrtr_metric;
array[DEVCONF_ACCEPT_RA_MIN_HOP_LIMIT] = cnf->accept_ra_min_hop_limit;
array[DEVCONF_ACCEPT_RA_PINFO] = cnf->accept_ra_pinfo;
#ifdef CONFIG_IPV6_ROUTER_PREF
@ -6668,6 +6671,14 @@ static const struct ctl_table addrconf_sysctl[] = {
.mode = 0644,
.proc_handler = proc_dointvec,
},
{
.procname = "ra_defrtr_metric",
.data = &ipv6_devconf.ra_defrtr_metric,
.maxlen = sizeof(u32),
.mode = 0644,
.proc_handler = proc_douintvec_minmax,
.extra1 = (void *)SYSCTL_ONE,
},
{
.procname = "accept_ra_min_hop_limit",
.data = &ipv6_devconf.accept_ra_min_hop_limit,

View File

@ -1173,6 +1173,7 @@ static void ndisc_router_discovery(struct sk_buff *skb)
struct neighbour *neigh = NULL;
struct inet6_dev *in6_dev;
struct fib6_info *rt = NULL;
u32 defrtr_usr_metric;
struct net *net;
int lifetime;
struct ndisc_options ndopts;
@ -1303,18 +1304,21 @@ static void ndisc_router_discovery(struct sk_buff *skb)
return;
}
}
if (rt && lifetime == 0) {
/* Set default route metric as specified by user */
defrtr_usr_metric = in6_dev->cnf.ra_defrtr_metric;
/* delete the route if lifetime is 0 or if metric needs change */
if (rt && (lifetime == 0 || rt->fib6_metric != defrtr_usr_metric)) {
ip6_del_rt(net, rt, false);
rt = NULL;
}
ND_PRINTK(3, info, "RA: rt: %p lifetime: %d, for dev: %s\n",
rt, lifetime, skb->dev->name);
ND_PRINTK(3, info, "RA: rt: %p lifetime: %d, metric: %d, for dev: %s\n",
rt, lifetime, defrtr_usr_metric, skb->dev->name);
if (!rt && lifetime) {
ND_PRINTK(3, info, "RA: adding default router\n");
rt = rt6_add_dflt_router(net, &ipv6_hdr(skb)->saddr,
skb->dev, pref);
skb->dev, pref, defrtr_usr_metric);
if (!rt) {
ND_PRINTK(0, err,
"RA: %s failed to add default route\n",

View File

@ -4252,11 +4252,12 @@ struct fib6_info *rt6_get_dflt_router(struct net *net,
struct fib6_info *rt6_add_dflt_router(struct net *net,
const struct in6_addr *gwaddr,
struct net_device *dev,
unsigned int pref)
unsigned int pref,
u32 defrtr_usr_metric)
{
struct fib6_config cfg = {
.fc_table = l3mdev_fib_table(dev) ? : RT6_TABLE_DFLT,
.fc_metric = IP6_RT_PRIO_USER,
.fc_metric = defrtr_usr_metric,
.fc_ifindex = dev->ifindex,
.fc_flags = RTF_GATEWAY | RTF_ADDRCONF | RTF_DEFAULT |
RTF_UP | RTF_EXPIRES | RTF_PREF(pref),