2017-12-08 15:46:09 +00:00
|
|
|
Microsemi Ocelot pin controller Device Tree Bindings
|
|
|
|
|
----------------------------------------------------
|
|
|
|
|
|
|
|
|
|
Required properties:
|
2018-12-20 14:44:31 +00:00
|
|
|
- compatible : Should be "mscc,ocelot-pinctrl" or
|
|
|
|
|
"mscc,jaguar2-pinctrl"
|
2017-12-08 15:46:09 +00:00
|
|
|
- reg : Address and length of the register set for the device
|
|
|
|
|
- gpio-controller : Indicates this device is a GPIO controller
|
|
|
|
|
- #gpio-cells : Must be 2.
|
|
|
|
|
The first cell is the pin number and the
|
|
|
|
|
second cell specifies GPIO flags, as defined in
|
|
|
|
|
<dt-bindings/gpio/gpio.h>.
|
|
|
|
|
- gpio-ranges : Range of pins managed by the GPIO controller.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
The ocelot-pinctrl driver uses the generic pin multiplexing and generic pin
|
|
|
|
|
configuration documented in pinctrl-bindings.txt.
|
|
|
|
|
|
|
|
|
|
The following generic properties are supported:
|
|
|
|
|
- function
|
|
|
|
|
- pins
|
|
|
|
|
|
|
|
|
|
Example:
|
|
|
|
|
gpio: pinctrl@71070034 {
|
|
|
|
|
compatible = "mscc,ocelot-pinctrl";
|
|
|
|
|
reg = <0x71070034 0x28>;
|
|
|
|
|
gpio-controller;
|
|
|
|
|
#gpio-cells = <2>;
|
|
|
|
|
gpio-ranges = <&gpio 0 0 22>;
|
|
|
|
|
|
|
|
|
|
uart_pins: uart-pins {
|
|
|
|
|
pins = "GPIO_6", "GPIO_7";
|
|
|
|
|
function = "uart";
|
|
|
|
|
};
|
|
|
|
|
|
|
|
|
|
uart2_pins: uart2-pins {
|
|
|
|
|
pins = "GPIO_12", "GPIO_13";
|
|
|
|
|
function = "uart2";
|
|
|
|
|
};
|
|
|
|
|
};
|
